Canon PC170 Operator's Manual download pdf (Page 12)

Getting Started

10

1

Handling Precautions

Platen

• Do not stack objects onto, or press down

forcefully upon, the platen.

• The maximum allowable load that can be

placed on the cover is 4.4 lb.

Main Unit

• Do not let paper clips, staples, or other

foreign objects fall into the copier.

Also be careful not to spill any liquids or

flammable substances (such as paint

thinner, benzene or rubbing alcohol) on

the copier. If a foreign object or liquid

comes into contact with a dangerous

voltage point inside the copier

malfunction, fire or electrical shock could

occur.

• Do not lubricate any part of the copier.

• Do not use any extremely flammable

substances, such as aerosols, etc., near

the copier as such a substance may

ignite.

HandlingHandling

PrecautionsPrecautions

When not Using the Copier

• If you have to open the main unit to

replace the cartridge or remove jammed

paper, close the top cover immediately

after performing the necessary operation.

Also be sure to slide the platen back to its

original position.

• If a cover is to be placed over the copier,

be sure to turn OFF the power and allow

the copier to cool down beforehand.

• Should the copier not be operated for a

long period of time, unplug it from its

power source.

When Storing the Copier

Upright

• If the copier is to be stored upright with the

carrying handle on top, press the power

switch to OFF and let the copier cool down

beforehand. Stand the copier upright on a

flat, level surface so that it does not fall

over.

• If the copier has been stored upright,

move the platen all the way to the right

and then back to the center position by

hand before operating the copier.

Condensation

If the copier is brought from the cold

outdoors into a warm room, or if the room is

rapidly heated, condensation may form inside

the copier. This can adversely affect the

quality of your copy images (e.g., blacked-

out copies). When the copier is exposed to

such conditions, allow at least two hours for

the copier to fully adjust to room temperature

before attempting to use it.

WARNING:

• If there is an unusual noise, smoke, or anything

else which causes concern, immediately turn

the power switch OFF and unplug the copier.

Then consult your service representative.

01_PC170-USA 06.5.15, 18:2610

Downloaded from ManualsPrinter.com Manuals

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Comments to this Manuals

No comments