Canon PIXMA MP130 Service Manual download pdf (Page 13)

1-7

“COLOR INK LOW”

Cause: The ink level in the color ink tank is low.

Solution: Make sure you have a new color ink tank ready to replace the used one when ink runs out. If the

machine stops printing when copying or photo printing, you can continue printing by pressing the

[OK] button. However, note that ink may run out. If print quality deteriorates or the print out is blank,

replace the ink tank.

“COVER OPEN”

Cause: You opened the scanning unit (printer cover) during an operation.

Solution: Close the scanning unit (printer cover).

Cause: Cover sensor failure.

Solution: Replace the cover sensor.

“PUT IN CARTRIDGE”

Cause: The print head is not set in this machine.

Solution: Set the print head.

“PLEASE CLEAR PAPER JAM AND PRESS [OK]”

Cause: There is a recording paper jam.

Solution: Clear the recording paper jam and press the [OK] button.

“PLEASE L

OAD PAPER AND PRESS [OK]”

Cause: The multi-purpose tray is empty.

Solution: Load paper in the multi-purpose tray. Make sure that the stack is below the paper limit mark. Then

press the [OK] button.

“WASTE NEAR FULL”

Cause: The waste ink tank absorber (which holds the ink used for print head cleaning) is nearly full.

Solution: If the “CHECK PRINTER” message is displayed, select “COUNTER ACCESS” in the Service Mode

and input “0” at the waste ink counter. After that, replace the ink tank absorber.

“WRONG CARTRIDGE”

Cause: The print head is not installed correctly.

Solution: Install the print head correctly.

Cause: The print head failure.

Solution: Replace the print head.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

No comments

Canon PIXMA MP130 Service Manual Page 13