Canon M15-155 User Manual download pdf (Page 10)

Chapter 2 Installation

8 M15-155 Installation Guide

Power-on Check

When you plug in the M15-155, wait until first the CPU LED lights and then the

OPR lights steadily before commencing work. If there are several M15-155

modules, one module will be elected as the Master Agent, and the NMA LED on

that module will also light ON. For a detailed explanation of the Master Agent

please refer to the Avaya M770 ATM Switch User’s Guide.

Connecting the Console Terminal

Initial software configuration of the M15-155 is done using a console terminal

connected to the Console connector on the front panel of the module. See the

Appendix for connector pin assignments.

To connect the M15-155 to a console terminal:

1. Turn on the VT100 terminal (or PC terminal emulator in VT100 or VT52 mode)

and set its communication parameters to:

Baud rate: 9600 bps

Start bit: 1

Data bits: 8

Stop bit: 1

Parity: None

Refer to your terminal’s user manual for instructions on how to set these

parameters.

2. Insert the RJ-45 connector of the cable into the Console port on the M15-155

front panel (see Table 3 for connector pinout).

3. Insert the other end of the cable into the terminal’s RS-232 port.

4. Press <Enter> to verify that the cabling process was successful. The system

prompt appears (M770sXX:/>).

5. The CLI commands and the explanation of how to configure the switch are

described in the Avaya M770 ATM Switch User’s Guide.

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Canon M15-155 User Manual Page 10