Canon BJC50 User Manual download pdf (Page 124)

114

Appendix C

Printer Command Summaries

Printer control codes are listed under each of the two printer control modes: BJ mode and LQ mode.

Printer control codes tell the printer how to print a job.

You can send commands in several ways:

You can use your software application to automatically embed certain commands (such

as bold, underline, or indent) within a document. Your software application usually

displays a symbol (such as B for bold) or changes the appearance of the displayed text

to indicate the embedded commands. When the document prints, the embedded

commands control the way the printer produces the printed page. See your software

application manual for instructions on sending commands.

You can send specific commands directly to the printer, using either a BASIC

statement or a printer command option in your software application.

Entering a setup string in Lotus 1-2-3

The procedure for entering printer control commands in Lotus 1-2-3 is typical of the procedures used

in spreadsheet software applications. If you are using another spreadsheet, review your application

manual to determine if your software application supports printer option setups. Although the

procedure to enter the codes may differ slightly, you will still have to enter the same number codes.

For a list of these codes, refer to the tables later in this appendix.

114

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 140 141

No comments

Canon BJC50 User Manual Page 124