Handling rolls
Handling rolls
Selecting the Roll as the Paper Source
Y ou can switch between manual and auto paper feed methods by pressing the Feeder Selection button. The
Auto Feed lamp is lit when paper is supplied automatically , and the Paper T ray lamp is lit for sheets.
Y ou must specify the auto paper feed method when using rolls. Press the Feeder Selection button to
activate the Auto Feed lamp (a).
Caution
• Paper jams may occur if you load paper other than the paper specied in the paper settings for the
media source.
Note
• Y ou cannot switch the paper source in the following situations:
• If the Message lamp is ashing
Check the message on the Display Screen and take action as necessary . ( → P .696)
• If the Data lamp is ashing
Select the paper source after printing.
• If a printer menu operation is in progress
Select the paper source after the menu operation.
• When in the process of loading paper
Finish loading the paper before selecting the paper source.
• When in the process of replacing Ink T anks
Finish replacing the Ink T anks before selecting the paper source.
• If the T op Cover is open
Close the T op Cover before selecting the paper source.
At this point, load the roll. ( → P .124)
Note
• If any paper is loaded that will not be used, remove it before loading the roll.
( → P .128)
( → P .176 )
120 Handling Paper
Comments to this Manuals