Canon Wireless File Transmitter WFT-E2 II A User Manual download pdf (Page 14)

This section describes the process of following the connection wizard instructions. If an error is

displayed, refer to “Troubleshooting” in Chapter 8 (p.71) and check the settings.

Pressing the shutter button or other camera controls during configuration by the connection

wizard will close the connection wizard. Do not press the shutter button or other controls

until configuration is finished.

On the [5] tab, set [Auto power off] to [Off]. If auto power off is activated, the connection

wizard will be closed during the configuration process.

Turn the camera on.

Display the transmitter menu.

On the camera, press the <7> button.

On the [7] tab, select [WFT settings] and press

<0>. [WFT settings] is added to the tab after you

attach the transmitter.

Select [Connection wizard].

X The [Select communication method] screen is

displayed.

X The <

LAN

> lamp starts blinking.

Displaying the Connection Wizard

Although terminology on the [Select communication method] screen has been updated since the

WFT-E2, the functionality is the same.

Cameras updated with firmware versions enabling the use of WFT-E2 II will display the same

information for [Select communication method] and [Communication mode] whether WFT-E2

or WFT-E2 II is attached.

COPY

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

No comments

Canon Wireless File Transmitter WFT-E2 II A User Manual Page 14