Canon imageCLASS MF6540 Owner's Manual download pdf (Page 39)

TOP

Back Previous Next

2-25

Introduction

Scanning a

Document

Troubleshooting

Appendix

Table of Contents

Index

Creating a Cropping Frame

Select (Crop) on the toolbar, click on the preview image and

drag over the area you wish to select. To make further

adjustments, drag the corner or edge of the selected frame or

enter the desired parameter values for (Width) and

(Height) in [Input Settings] on the [Advanced Mode] tab

sheet. To move the cropping frame you have selected, click

inside the cropping frame and drag.

NOTE

– To maintain the current width and height proportion of the image,

click in [Input Settings].

– When using the ADF, creating a new cropping frame will erase an

existing one.

Creating Multiple Cropping Frames (Only when

Using the Platen Glass)

You can create another cropping frame even if there is already

one in the preview area. Click and drag the mouse cursor

outside the existing cropping frame to create a new cropping

frame in that area.

You can create up to 10 cropping areas. By clicking [Scan] once,

all the cropped areas will be scanned. (Scanning will continue

until all selected areas have been scanned.)

The most recently created cropping frame will become the focal

point. To make adjustments to previously created cropping

frames, select the frame or frames by clicking on them.

Deleting Cropping Frames

If you want to remove cropping frames, select the frame or

frames and do one of the following:

– Click [Delete] on the keyboard.

– Click (Remove Cropping Frame) on the toolbar.

– Right-click on the cropped area and select [Delete].

– Hold down [Ctrl] on the keyboard, right-click outside the cropped

area, and select [Delete].

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 81 82

Comments to this Manuals

No comments

Canon imageCLASS MF6540 Owner's Manual Page 39

Comments to this Manuals

Related products and manuals for Scanner Transparancy Adapters Canon imageCLASS MF6540