Canon REALiS X600 User Manual download pdf (Page 65)

User Command Specifications

9. Details of command LOGOPOS

LOGOPOS

LOGOPOS=<User image position setting parameters：ＩＤ>

User image position setting parameters

This sets the logo display position.

-1

A "busy" response is given while the zoom or focus lens is being driven.

-2

[Display settings] - [User screen settings] - [User image position]

-3

-4

Setting

> LOGOPOS=UPPER_R This sets the logo display position to the upper right.

< i:OK

Reference

> GET LOGOPOS or ?LOGOPOS This retrieves the logo display position.

< g:LOGOPOS=LOWER_L

Acquisition of parameters which can be set

> RANGE LOGOPOS

< r:LOGOPOS=I,UPPER_L,UPPER_R,CENTER,LOWER_L,LOWER_R

* Commands are indicated by ">", and responses are indicated by "<".

Supported Command State

OFF ON PM

× ○ ×

* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.

* "i:BUSY" may be returned if the power status is being switched.

It can be executed when the projector is in both the remote mode and power-on status at the

same time.

"UPPER_L," "UPPER_R,"

"CENTER," "LOWER_L" or

"LOWER_R" can be set as the

user image position.

01.01** 01.01**

The current display position can be acquired using the applicable GET command.

SX60

X600

This command is the same as the menu functions in the table below.

SX50 SX6 SX60 X600

○

01.00**

This setting cannot be made unless the user screen is registered beforehand.

(Error "e:1002 NO_LOGO_CAPTURED" is returned.)

(Refer to the ZCONTDRV command and FCONTDRV command.)

Response

Example

"i:OK" is returned if the parameter was set properly.

For details, refer to the GET command.

Description

Model

SX50

SX6

Commands

CENTER

UPPER_L

Paramete

UPPER_R

Function

Parameter

Lower left

Meaning

Upper lef

Lower righ

Upper right

Center

Model Power

Input Mode

Remote Local

Remarks

D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None

SX50

○○○○○○ ––○○ ×

SX6

○○○○○○○○○○ ×

SX60

Format

X600

Reference

The parameters which can be set at any given point in time can be obtained using the

RANGE command.

For details, refer to the RANGE command.

For all other responses, refer to "Error List."

LOWER_R

LOWER_L

User image position settin

Mode Control Setting

Command

supported

○○○

01.01**

PAGE 57

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 189 190

Comments to this Manuals

No comments

Canon REALiS X600 User Manual Page 65

Comments to this Manuals

Related products and manuals for Data projectors Canon REALiS X600