Canon FaxPhone L120 User's Guide download pdf (Page 40)

TOP

Back Previous Next

4-6

Advanced Fax

Features

Status Monitor

Reports and Lists

Troubleshooting

Appendix

Table of Contents

Index

■ Receiving Problems

Errors occur frequently while sending.

Q Are the telephone lines in poor condition, or do

you have a bad connection?

A Check if there is a device nearby that interferes

with signal transmission (i.e., microwave oven).

Cannot receive a fax automatically.

Q Is the machine set to receive automatically?

A For the machine to receive faxes automatically, the

receive mode must be set to <FAX/TEL>, <FAX

ONLY>, <AnsMode>, or <DRPD>. If you have set

<AnsMode>, confirm that an answering machine is

connected to the machine and that it is turned on

with an outgoing message properly recorded. (See

“Setting the Receive Mode,” on p. 1-6.)

Q Is a document stored in memory, leaving little

or no memory available?

A Print, send, or delete any documents stored in

memory.

Q Has an error occurred during reception?

A Check the LCD for an error message. (See

Chapter 9, “Troubleshooting,” in the Basic Guide.)

A Print an Activity Report and check for an error.

(See “Printing Reports and Lists,” on p. 2-3.)

Q Is paper loaded in the machine?

A Make sure paper is loaded in the machine. (See

“Load Paper,” in the Starter Guide.)

Q Is the telephone cable connected properly?

A Make sure the cable is connected properly. (See

“Connect Telephone Cables and Install Handset,”

in the Starter Guide.)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 57 58

No comments

Canon FaxPhone L120 User's Guide Page 40