Handling rolls
Handling rolls
Selecting the Paper Source
When advancing paper , press the Feeder Selection button and select the source.
Y ou can determine the selected source by checking which lamp is lit-either the Auto Feed lamp (a) or the Paper
T ray lamp (b).
• Auto Feed lamp : Selected when printing on Roll Media or the Cassette .
• Paper T ray lamp : Selected when printing on Sheets from the T op Paper Feed Slot or Front Paper
Feed Slot .
Note
• If any paper is loaded that will not be used, a message is shown on the Display Screen (either Remove
RllMedia? or Remove CutSheet? ) when you press the Feeder Selection button.
T o remove the paper , press the OK button. ( → P .141)
• Y ou cannot switch the paper source in the following situations:
• If the Message lamp is ashing
Check the message on the Display Screen and take action as necessary . ( → P .674)
• If the Data lamp is ashing
Select the paper source after printing.
• If a printer menu operation is in progress
Select the paper source after the menu operation.
• When in the process of loading paper
Finish loading the paper before selecting the paper source.
• When in the process of replacing Ink T anks
Finish replacing the Ink T anks before selecting the paper source.
• If the T op Cover is open
Close the T op Cover before selecting the paper source.
Handling Paper 1 1 1
Comments to this Manuals