LV- WX300/X300/S300 (7/7)
■
Accessories
Supplied
Projector Remote Controller
LV-RC08
Power source: DC 3.0V (uses CR2025 battery)
Operating range: Distance of approx. 8 m from the
projector; angle of ±30° in any direction from directly in
front of the infrared remote receiver.
Computer Cable
Mini Dsub15-MiniDsub15
Used to connect the projector to a PC for transferring
analog PC signals.
Options
Projector Remote Controller
LV-RC08
Same as the supplied accessory.
Soft Carrying Case
LV-SC01
Soft carrying care for the LV-WX300, LV-X300, LV-S300,
LV-WX300ST, and LV-X300ST models
Replacement
Parts
Replacement Lamp
LV-LP37
Ultra high-pressure mercury lamp for the LV-X300 and
LV-S300 models
Recommended replacement time*
1
: 5000H/6000H (Lamp
mode: Normal/Eco)
Replacement Lamp
LV-LP39
Ultra high-pressure mercury lamp for the LV-WX300
model
Recommended replacement time*
1
: 5000H/6000H (Lamp
mode: Normal/Eco)
*1: When the lamp has a 50% survival rate and can maintain a 50% light retention ratio.
■
Precautions when installing/using
High wattage lamps are used in the projector, and it becomes very hot. Take care as follows.
(1) This projector produces intense light from the projection lens. Do not stare directly into the lens, otherwise damage to eyes
could result.
(2) Do not set anything on top of the projector. Also do not project with projectors stacked directly on top of each other.
(3) Do not place any object in front of the lens while the projector is in use as focused light projected to an object for a prolonged
time may result in a fire.
(4) Do not block the intake and exhaust vents of the projector.
Also, install the projector so that the intake and exhaust vents are not subjected directly to warm air and cold air of air
conditioning.
(5) The projector uses high-pressure mercury lamp for its light source, which may deteriorate or reduce luminance owing to the
characteristics and extensive use of the mercury lamp. Prolonged usage may also lead to breakage of the lamp. In such
instances, immediately replace the lamp to a new lamp. Contact a local dealer for service and replacement of the lamp; such
maintenance should be conducted at a service center by a qualified personnel.
(6)
When operating the projector inserted in a box, ensure that the ambient temperature within the box during operation is within
the range of 0°C to 40°C. Also, do not block the intake and exhaust vents. Even when the ambient temperature is 40°C or
lower, the protection circuit of the projector may function and shut down the projector due to internal retention of the exhaust
heat. Sufficiently consider the ambient temperature environment when installing the projector.
(7)
Set the Fan Control mode (High altitude mode) to ON when using the projector in high altitudes (1,500 meters or move
above sea level) where the atmospheric pressure is low.
(122 pages)
(124 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals