Canon IRC2100 Service Manual download pdf (Page 81)

4-9 Proﬁle Manager

3. Select the “Appear in Driver as” checkbox, choose one of the predeﬁned

custom simulation names (Simulation-1 through Simulation-10) from the

pop-up menu, and then click Apply.

Make sure to choose a name that is not already linked with another

simulation. If you try to deﬁne two proﬁles with the same name, you will get

an error message.

For an output proﬁle, the predeﬁned custom names would be Output-1

through Output-10.

NOTE: While you cannot delete a preset proﬁle, you can use a preset proﬁle’s

name for your downloaded proﬁle when you select the “Appear in Driver as”

option. This replaces the preset proﬁle with your own proﬁle.

When you choose Proﬁle Settings for an output proﬁle, the Use Calibration

Set option also appears. You must calibrate the iR C2100/2100S with this

calibration set before this option has any effect. If you have never measured

for this calibration set, default measurements will be used. For more

information about calibration sets, see page 3-2.

In Proﬁle Settings you can also change proﬁle descriptions for all non-locked

proﬁles.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 163 164

No comments

Canon IRC2100 Service Manual Page 81