Canon 3000 V User Manual download pdf (Page 33)

Take the picture.

Compose the shot and press the

shutter button fully.

•ir30"” and the maximum aperture value blink, it

indicates underexposure. Use flash.

•If" ?0DD ” and the minimum aperture value blink, it

indicates overexposure. Use an ND filter to reduce

the light entering the lens.

The Difference Between <P> and <0>

• The shutter speed and aperture value are set in the same way in

both modes.

• The following features can be used in the <P> mode, but not in

the <0> mode.

Manual AF point selection

Film advance mode selection

Program shift

Exposure compensation

AEB

AE lock with the <■ )(■ > button

Multiple exposures

Built-in flash manual firing and

flash OFF

FE lock, high-speed sync

(with EX-sehes Speedlites)

About Program Shift

• In the Program AE mode, you can freely change the shutter speed

and aperture value combination (program) set by the camera while

retaining the same exposure. This is called program shift.

• To shift the program, press the shutter button halfway and turn the

<£Sa> dial until the desired shutter speed or aperture value is

displayed.

• Program shift is canceled automatically after the picture is taken.

• Program shift cannot be set when the built-in flash is used.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

No comments

Canon 3000 V User Manual Page 33