Canon WUX6000 User Manual download pdf (Page 104)

104

Customizing System Operation (System Settings)

Requiring a Password

for Operation

> [System settings] > [Other settings] >

[Password settings]

Disables the projector unless the

correct password is entered.

Press the OK button to accept your

setting and then press the MENU

button.

• [Off] is the factory default.

• You cannot set [On] unless you have

completed [Register password].

Once you set a password, the

password entry screen appears at

power-on.

Enter a 4 digit password.

Enter the password using the [ ] / [ ] /

[ ] / [ ] buttons.

If the password is valid, the projection

starts. If you enter a wrong password

three times, the power will be turned off.

• The power is also turned off if no password

is input for 3 minutes.

HDMI Component LAN

Digital PC Analog PC USB

Off The projector can be used even if no

password is entered.

On The projector cannot be used unless

you enter your password.

To Cancel the Password

• Cancellation on the Projector

Turn off the projector and unplug the

power plug.

Hold down the MENU button on the side

control and connect the power plug.

Make sure to keep holding down the

MENU button until a beep sounds. When

the beep sounds, the password is

canceled. (The entered password is also

reset.)

• Cancellation on the Remote Control

To forcibly cancel the password from the

remote control, in standby state press the

MENU button 3 times, then press the

POWER button.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 235 236

Comments to this Manuals

No comments