Canon WITE32 Specifications download pdf (Page 16)

WITE32 Release Notes Version 3.20

To switch the Lock Motors mode on or off, select or clear the Enable Lock Motors Mode check box on the Motor

Params tab. This tab is a part of the Spinstand Parameters tab set of the WDCP2002 dialog box (see Figure 6).

If you perform the reset, when the Lock Motors mode is enabled, the software will show the warning message “Linear

Motors are locked by software”. You need to switch the Lock Motors mode off in order to reset the spinstand.

Note:

Figure 6: Motor Params Tab of Spinstand Parameters Tab Set (WDCP2002)

3.3.4 Selecting Disk Chuck Type in WDCP2002

To support the disk chucks with the different types of clamping, the new Disk Chuck Type text box with the

drop-down list is added on the Spindle Params tab. This tab is a part of the Spinstand Parameters tab set of the

WDCP2002 dialog box (see Figure 7).

Figure 7: Disk Chuck Type Text Box on Spindle Params Tab (WDCP2002)

16 Guzik Technical Enterprises

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

Canon WITE32 Specifications Page 16