Canon 240 HS User Manual download pdf (Page 193)

Using an Eye-Fi Card

193

Check the access point SSID used by the Eye-Fi card or the connection

status, as needed.

z Touch H, touch n, and then touch

[Eye-Fi Settings] on the 3 tab to choose it.

z Touch [Connection info].

X The connection information screen is

displayed.

Configure the setting as follows to disable Eye-Fi transfer by the card, if

necessary.

Choose [Disable] in [Eye-Fi trans.].

z Touch H, touch n, and then touch

[Eye-Fi Settings] on the 3 tab to choose it.

z Choose [Eye-Fi trans.], and then choose

[Disable].

• Power saving (p. 46) on the camera is temporarily disabled during image

transfer.

• Choosing mode will interrupt the Eye-Fi connection. Although the Eye-Fi

connection will be restored after you choose another shooting mode or enter

Playback mode, the camera may transfer any movies made in mode again.

Checking Connection Information

Disabling Eye-Fi Transfer

• [Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camera

with its write-protect tab in the unlocked position. For this reason, you

cannot change settings for an inserted Eye-Fi card if the write-protect

tab is in the locked position.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 219 220

No comments

Canon 240 HS User Manual Page 193