Canon XF105 User Manual download pdf (Page 33)

Preparing the Camcorder

Using the Wireless Controller to Operate the Camcorder

When using the wireless controller, point it at the camcorder’s remote

sensor. When the wireless controller's buttons are operated, the

camcorder's tally lamps will illuminate.

NOTES

• When you use the START/STOP button or ZOOM buttons on the wireless

controller, you must press the record enable button simultaneously with

the desired button.

• When the camcorder cannot be operated with the wireless controller, or when it can only be operated at very

close range, replace the battery.

• The wireless controller may not work properly when the remote sensor is located under strong light sources or

direct sunlight.

Using a Tripod

You can mount the camcorder on a tripod but do not use tripods with

mounting screws longer than 5.5 mm as this may cause damage to the

camcorder.

Using a Tripod with 0.95 cm (3/8") Mounting Screws

To use a tripod with 0.95 cm (3/8") mounting screws, first attach the

optional TB-1 Tripod Adapter Base to the camcorder and then attach the

tripod to the adapter base.

1 Remove the tripod base from the camcorder.

• Remove the 4 screws and then remove the base.

2 Attach the optional TB-1 Tripod Adapter Base.

• Firmly screw in the 4 screws.

3 Attach the tripod.

• Firmly screw in the tripod screw.

• If a tripod has both a 0.64 cm (1/4") screw and 0.95 cm (3/8")

mounting screw, firmly screw in both.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 176 177

No comments

Canon XF105 User Manual Page 33