Canon X300ST User Manual download pdf (Page 42)

Adjusting the sound

The sound adjustments made as below will have an effect on the projector speaker. Be sure you have

made a correct connection to the projector audio input. See "Connection" on page 23 for how the audio

input is connected.

Muting the sound

To temporarily turn off the sound, press MUTE on the remote control,

or:

1. Press MENU and then press / until the SYSTEM SETUP:

Advanced menu is highlighted.

2. Press to highlight Audio Settings and press OK/IMAGE. The

Audio Settings page is displayed.

3. Highlight Mute and press / to select On.

Adjusting the sound level

To adjust the sound level, press VOL +/- on the remote control, or:

1. Repeat steps 1-2 above.

2. Press to highlight Volume and press / to select a desired sound level.

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do

not affect the projection settings, operation, or performance.

• Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of

time the OSD will remain active after your last key press. The time length ranges from 5 to 30

seconds in 5-second increments. Use / to select a suitable time frame.

• Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position

in five locations. Use / to select a preferred position.

• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD menus.

See "Using the menus" on page 29 for details.

• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed

during projector start-up. Use / to select a screen.

Shutting down the projector

1. Press POWER and a confirmation message displays

prompting you.

If you don't respond in a few seconds, the message will disappear.

2. Press POWER a second time. The POWER indicator light

flashes orange, the projection lamp shuts down, and the fans will

continue to run for approximately 90 seconds to cool down the

projector.

3. Once the cooling process finishes, the POWER indicator light

is a steady orange and fans stop.

4. Disconnect the power cord from the wall socket if the projector

will not be used in an extended period of time.

• To protect the lamp, we suggest you not to operate the

projector during the cooling process.

• To shorten the cooling time, you can also activate the Quick Cooling function. See "Quick

Cooling" on page 57 for details.

• Do not unplug the power cord before the projector shutdown sequence is complete or during

the 90-second cooling down process.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 76 77

Comments to this Manuals

No comments

Canon X300ST User Manual Page 42

Comments to this Manuals

Related products and manuals for Data projectors Canon X300ST