Canon VB-M40B User Manual download pdf (Page 59)

5-15

Setting Page

General Upload

[Upload]

Select [Upload Disabled], [HTTP Upload] or [FTP

Upload] for the upload method.

Note

The server or network load may increase and the frame rate may

drop, depending on the settings. If this occurs, try the following

measures. Also check the settings including the network to the

server.

• Reduce the image file size:

– Set a lower value under [Image Quality] for JPEG (p. 5-13).

– Set a lower value for [Image Size: Upload] for JPEG

(p. 5-13).

• Reduce the uploading frequency:

– Reduce the value in [Pre-event Buffer (number of image

frames)] or [Post-event Buffer (number of image frames)]

(p. 5-20).

– If [Volume Detection Event] is enabled, disable [ON Event

Operation] or [OFF Event Operation] (p. 5-20).

– From the Intelligent Function Setting Tool [Event] tab >

disable [ON Event Operation], [OFF Event Operation] or

[Detected mode Operation] (p. 6-28).

– If [External Device Input Event] is enabled, disable [ON

Event Operation] or [OFF Event Operation] (p. 5-21).

– If [Timer Event Setting] is enabled, increase the value in

[Repeat Interval] (p. 5-22).

HTTP Upload

The HTTP upload function sends notifications via HTTP or

via HTTP with attached video, depending on the network

camera event.

(1) [Notification]

Select [Notification Only with HTTP] or [Image

attached Notification with HTTP] as the content of

notification.

(2) [URI]

Enter the URI to be uploaded to (using up to 255

characters).

(3) [User Name], [Password]

Enter the user name and password required for

authentication.

Digest authentication is not supported.

(4) [Proxy Server]

Enter the host name or IP address of the proxy server

(using up to 63 characters).

(5) [Proxy Port]

Enter the port number of the proxy server (factory

default setting is [80]).

(6) [Proxy User Name], [Proxy Password]

Enter the user name and password of the proxy

server.

Digest authentication is not supported.

[Upload]

Setting HTTP/FTP Upload and E-mail Notification

The following can be set here.

• General Upload

Set the upload operation to be performed.

• HTTP Upload

Set HTTP connection uploads.

• FTP Upload

Set FTP connection uploads.

• E-mail Notification

Set event information and image e-mail

notifications.

Important

• If the upload function is used, either the [Event] menu must

be set (p. 5-20) or the [Event] tab in the Intelligent Function

Setting Tool (p. 6-25) must be set.

• If you are using both e-mail notification by text and image

upload by HTTP/FTP, set [Image Size: Upload] (p. 5-13) to

[320 x 240] or less.

• HTTP upload does not support SSL/TLS.

• If the camera is set to perform upload or e-mail notification

continuously, not all images or e-mails may be sent

depending on the image size and the network condition to

the server. In this case, an event log message is displayed

(p. 5-33).

• If the destination for HTTP/FTP upload or e-mail notification is

set for a Windows operating system, IPsec communication

cannot be applied.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 158 159

Comments to this Manuals

No comments

Canon VB-M40B User Manual Page 59

Comments to this Manuals