Canon ImageCLASS MF5750 User Manual download pdf (Page 21)

4-1

CHAPTER

Sending Faxes

This chapter describes the different ways to send faxes. It also explains how to adjust scan settings to improve the

image quality.

Sending Methods

There are two methods of sending faxes from the machine:

- Memory Sending

- Manual Sending

NOTE

•

You can also fax the documents from your computer. If you want to install the software for fax sending, see the

following:

- "Install software," in the Set-Up Sheet

- Chapter 1, "Installation," in the Software Guide

•

For details on how to send faxes from your computer, see Chapter 4, "PC Faxing (MF5750/MF5770 Models Only),"

in the Software Guide.

Memory Sending

You should normally use memory sending to send documents efficiently.

If <MEMORY FULL> is displayed, the machine cannot scan the documents. In this case, wait for the

machine to send any faxes stored in the memory, then scan the documents.

NOTE

You can register a new fax job while the machine is waiting to redial the recipient's number automatically. For

details on how to set the machine to redial automatically, see "Automatic Redialing," on p. 4-6. You can store up to

20 fax jobs or approximately 256 pages * in the memory.

* Based on the condition that the other party sends the fax by the LaserBase MF5750/MF5770. with Canon

Fax Standard Chart No. 1, standard mode.

Place the document on the platen glass or load it in the ADF ➞ press [FAX].

For details on the types of documents you can fax, their requirements, and how to place or load documents, see

Chapter 3, "Document Handling," in the User’s Guide.

Adjust any necessary settings for your document.

• Press [Image Quality] to select the fax resolution. (See "Adjusting the Image Quality (Fax Resolution)," on p.

4-3.)

• Press [Exposure] to select the scan density. (See "Adjusting the Exposure (Scan Density)," on p. 4-3.)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

No comments

Canon ImageCLASS MF5750 User Manual Page 21