Canon PIXMA MP495 Service Manual download pdf (Page 4)

(4/15)

Error

code

7-segment

LCD

Solution

No ink. [1688] E16 Replace the ink cartridge. Printing with an empty ink tank

can damage the machine.

To continue printing without replacing the ink cartridge,

press the Stop/Reset button for 5 sec. or longer. (After the

operation, it is recorded in the machine EEPROM that the

function to detect the remaining ink amount was disabled.)

Warning: The ink absorber

becomes almost full.

[1700] E08 Replace the ink absorber, and reset the ink absorber

counter. (See 2-1, "Service Mode.")

Pressing the Stop/Reset button will exit the error, and

enable printing without replacing the ink absorber.

However, when the ink absorber becomes full, no further

printing can be performed unless the applicable ink

absorber is replaced.

1-2. Service Call Error (Cyclic Blinking in Orange (Alarm LED) and Green (ON LED)

Cycles of

blinking in

orange and

green

Error

code

7-seg.

LCD

Conditions

Solution

(Replacement of listed parts, which are

likely to be faulty)

2 times Carriage error [5100] P02 An error occurred in the

carriage encoder signal.

1) Confirm that no foreign material is in the

area where the carriage moves.

2) Clean the timing slit film.

If it cannot be cleaned, replace it.

3) Replace the following items (listed in the

order of likeliness to be faulty):

- Carriage unit

- Logic board

3 times Line feed error [6000] P03 An error occurred in the LF

encoder signal.

1) Perform the following for the timing slit

disk film:

- Clean it.

- Re-attach it, if peeled off.

- Replace it, if it cannot be cleaned, or if

it is deformed or damaged.

2) Replace the following items (listed in the

order of likeliness to be faulty):

- Logic board

- Drive unit

5 times ASF cam

sensor error

[5700] P05 This error takes place when

feeding paper from the rear

tray after an error occurred

in the rear tray cam sensor.

1) Confirm that no foreign material is

around the drive gear on the side of the

drive unit.

2) Replace the following items (listed in the

order of likeliness to be faulty):

- Drive unit

- Logic board

6 times Internal

temperature

error

[5400] P06 The internal temperature is

not normal.

Replace the logic board.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Canon PIXMA MP495 Service Manual Page 4

Comments to this Manuals

Related products and manuals for Networking Canon PIXMA MP495