– Check the connection between your computer or video
equipment and the projector. See pages 17-19.
– See if the input signal is correctly output from your computer.
Some laptop computers may need to change the setting for
monitor output when connecting to a projector. See your
computer’s instruction manual for the setting.
– It takes about 30 seconds to display an image after turning on
the projector. See page 21.
– Check the Input signal, color system, video system or computer
system mode.
– Make sure the temperature is not out of the specified Operating
Temperature (41˚F–95˚F [5˚C–35˚C]).
– When is operating, the image cannot be displayed.
Press the BLANK button or any other button on the
remote control unit.
– Check the Input signal, color system,video system or computer
system mode.
– Make sure the is not selected on Image select
menu. See pages 34,41.
– Check the Display function. See page 48.
– Check the Input signal. Auto PC adjustment function can not
work when , , , 480i, 575i, 1035i or 1080i is
selected. See page 30.
– Make sure you selected after adjusting setting. Some
settings can not be stored if not registered with . See
pages 35,43.
– Power management mode function can not work while
or function is running. See page 51.
– Check the connection and the input signal to see if there is
signal.
–
Make sure is not selected at any function of.
– Check menu or menu and adjust them.
See pages 32-33, 37.
– PIN code lock is being set. Enter a PIN code (the “1234” or
numbers you have set). See pages 22, 55-56.
See page 47.
Comments to this Manuals