Canon EOS-1D Mark II User Manual Page 176
- Page / 196
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
176
If there is a problem, first refer to this Troubleshooting Guide.
You are using the wrong battery.
X Use the dedicated Ni-MH Pack. (p.22)
The battery is not properly attached to the charger.
X Attach the battery properly to the charger. (p.22)
The battery is exhausted.
X Recharge the battery. (p.22)
The battery is not installed properly.
X Install the battery properly. (p.25)
The memory card slot is open.
X Push in the memory card and close the memory card slot. (p.30)
If you set the <
4> switch to <2> right after shooting, the
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
X When the camera finishes recording the image to the memory
card, the access lamp will stop blinking and the power will turn off.
The battery is not fully charged.
X Recharge the battery fully. (p.22)
The battery’s service life has expired.
X Replace it with a new battery. (p.182)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the <
4
> switch is set to <
1
>.
The access lamp lights or blinks even when the
<
4
> switch is set to <
2
>.
The battery becomes exhausted quickly.
- INSTRUCTION MANUAL 1
- Test the Camera Before Using 2
- Copyrights 2
- Item Check List 3
- Contents 4
- Contents at a Glance 6
- Image Playback and Printing 7
- Safety Warnings 8
- Handling Precautions 10
- LCD Panels and LCD Monitor 11
- Memory Cards 11
- Lens Electrical Contacts 11
- Cautions for Prolonged Use 11
- Quick Start Guide 12
- Nomenclature 14
- Top LCD Panel 17
- Rear LCD Panel 18
- Viewfinder Information 19
- Getting Started 21
- Recharging the Battery 22
- Connect the battery 23
- Refreshing the Battery 23
- Lamp Indications 24
- Rubber lining 25
- Temperature Shots remaining 26
- Insert the DC Coupler 27
- Connect the DC plug 27
- Connect the power cord 27
- Mounting and Detaching a Lens 29
- 4> switch to <1> 31
- Basic Operation 33
- Pressing halfway (9) 34
- Pressing completely 34
- Shutter Button 34
- 6> dial until the desired 35
- 6> dial only 35
- 6> Dial 35
- 9). During 36
- Vertical Shooting 37
- Menu Operations 38
- 5> dial to select a tab 39
- 5> dial to select a menu 39
- 5> dial to select the 39
- N> button and <B> 42
- Dioptric Adjustment 43
- Holding the Camera 43
- 3 Setting the Language 44
- Select [Auto power off] 45
- Set the desired time 45
- 3 Setting the Date and Time 46
- 4> switch to <2> 47
- 3 Cleaning the CMOS sensor 48
- Clean the image sensor 49
- Exit the sensor cleaning 49
- Attaching the Neck Strap 50
- Image Settings 51
- Selecting the Image Size 52
- Select the Image Size 52
- About the RAW 53
- Setting the ISO Speed 55
- 3 Selecting a Picture Style 56
- Select [Detail set.] 58
- Select the style 58
- Select the parameter 58
- Set the desired setting 58
- Select [Monochrome] 59
- Monochrome Adjustment 59
- Filter effects 60
- Toning Effect 60
- Select [User Def. 1/2/3] 61
- 3 Setting the Color Space 63
- 3 Selecting the White Balance 64
- 3 Custom White Balance 65
- Select <O> 66
- Setting the Color Temperature 67
- White Balance Correction 68
- White Balance Auto Bracketing 69
- Set the camera to the folder 71
- Creating a New Folder 71
- Selecting a Folder 72
- Selecting the Memory Card 72
- JPEG g: RAW] 74
- 3 Setting the File Name 75
- 3 File Numbering Methods 76
- Continuous 77
- Manual Reset (M-Reset) 77
- Select [Noise reduction] 78
- Autofocus and 79
- Drive Modes 79
- Selecting the AF Mode 80
- 3 Take the picture 81
- SSelecting the AF Point 82
- C.Fn-13-1, 2 83
- C.Fn-13-3, 4 83
- Select the AF point to be 84
- Registering an AF Point 84
- P> button and <S> 85
- P> button to 85
- AF Point Activation Area 86
- S> button, the top 88
- Subjects difficult to focus 89
- Manual Focusing 90
- Selecting the Drive Mode 91
- Self-timer Operation 92
- Exposure Control 93
- Select the metering mode 94
- Evaluative Metering 94
- Partial Metering 94
- Spot Metering 94
- Center-weighted Averaged 95
- Metering 95
- AF Point-Linked Spot Metering 95
- I> button 96
- Check the display 98
- W> button and 100
- 6> dial 100
- Focus the subject 102
- Depth-of-field Preview 103
- 7> switch to <1> 104
- 6> dial to set the 104
- Take the picture 105
- Set the exposure 105
- Setting Exposure Compensation 106
- Set the AEB amount 107
- AEB with the ISO Speed 108
- AAE Lock 109
- Bulb Exposures 110
- Mirror Lockup 111
- Flash Photography 112
- 2 Focus the subject 113
- 5 Take the picture 113
- Sync Speed 114
- PC Terminal 114
- Non-Canon Flash Units 114
- Image Playback 115
- 3 Reviewing Images 116
- Select [Review time] 117
- Select the desired setting 117
- Image Review Time 117
- 3 Auto Image Rotation 118
- 3 Setting the LCD Brightness 119
- Playback the image 121
- 3 Highlight Alert 122
- 3 AF Point Display 122
- 3 Histogram Display 123
- X> button and 125
- M> button. The menu will 125
- Viewing the Images on TV 126
- J Image Protection 127
- Select [Protect images] 128
- KSound Recording for an Image 129
- Erasing Images 130
- L> button 131
- Select [Erase all on card] 132
- Erase the images 132
- 3 Formatting a Memory Card 133
- Press the <L> button 134
- About Low-level Formatting 134
- Preparing to Print 136
- Turn on the printer 137
- X> button 138
- Press the < 139
- > button 139
- Select [Paper Settings] 139
- QSetting the Paper Size 140
- YSetting the Paper Type 140
- USetting the Page Layout 140
- Set the other options 141
- Start printing 142
- APrinting with CP Direct 143
- Set the options as desired 144
- Set the number of copies 144
- Set the trimming 144
- Select [Style] 146
- Setting the Trimming 149
- Exit the menu 150
- DPOF: Digital Print 151
- Order Format 151
- Print Order 152
- Press the <7> button 153
- Select [Order] 154
- Set the print settings 154
- Selecting Individual Images 154
- Select [All] 155
- Selecting All Images 155
- Direct Printing with DPOF 157
- Customizing 159
- the Camera 159
- 3 Setting a Custom Function 160
- Custom Function Settings 161
- C.Fn-10 AF point illumination 164
- C.Fn-12 Mirror lockup 165
- C.Fn-14 E-TTL II 166
- 3 Custom Function Settings 167
- C.Fn-00 Focusing Screen 169
- 5> dial to select a group 170
- 5> dial to select [OK] 170
- Personal Functions 171
- 5> dial to select 172
- Save the camera settings 173
- Saving Camera Settings 173
- Reference 175
- Troubleshooting Guide 176
- Shooting 177
- Image Review & Operation 178
- Error Codes 179
- Changing the Focusing Screen 180
- Major Accessories (Optional) 182
- System Map 184
- Specifications 186
- • White Balance 187
- • Viewfinder 187
- • Autofocus 187
- • Exposure Control 188
- • Shutter 188
- • Drive System 189
- • LCD Monitor 189
- • Image Playback 189
- • Image Protection and Erase 189
- • Ni-MH Charger NC-E2 191
- • DC Coupler Kit DCK-E1 191
- Digital Camera Model DS126111 192
Related products and manuals for Software Canon EOS-1D Mark II
Software Canon EOS D60 User Manual
(16 pages)
(16 pages)
Software Canon ImageCLASS MF3240 User Manual
(38 pages)
Software Canon PowerShot S90 User Manual
(6 pages)
(6 pages)
Software Canon DC20 E Specifications
(206 pages)
(206 pages)
Software Canon EOS 60D User Manual
(4 pages)
(4 pages)
Software Canon Mk2500 Specifications
(60 pages)
(60 pages)
Software Canon PowerShot S100 User Manual
(26 pages)
(26 pages)
Software Canon A10 User Manual
(2 pages)
(2 pages)
Software Canon EOS 5D Mark III User Manual
(24 pages)
(24 pages)
Software Canon PowerShot G12 User Manual
(214 pages)
(214 pages)
Software Canon EOS-1D Mark IV User Manual
(48 pages)
(48 pages)
Software Canon PowerShot G11 User Manual
(193 pages)
(193 pages)
Software Canon EOS Rebel T1i User Manual
(228 pages)
(228 pages)
Software Canon EOS 550D User Manual
(260 pages)
(260 pages)
© 2020, manymanuals.com. All rights reserved. | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals