Canon FS20 Instruction Manual Page 101

  • Download
  • Add to my manuals
  • Print
  • Page
    / 123
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 100
101
SOME SCENES COULD NOT BE DELETED
- Movies that were protected/edited with other devices cannot be deleted.
TASK IN PROGRESS DO NOT DISCONNECT THE POWER SOURCE
- The camcorder is updating the memory. Do not disconnect the compact power adapter or remove the battery
pack.
THE CAMCORDER IS SET TO MOVIE MODE
- You pressed while the camera mode dial was set to .
THE CAMCORDER IS SET TO PHOTO MODE
- You pressed while the camera mode dial was set to .
THE CARD IS SET FOR ERASURE PREVENTION
- The LOCK switch on the SD or SDHC memory card is set to prevent accidental erasure. Change the position of
the LOCK switch.
THE MEMORY CARD COVER IS OPEN
- After inserting a memory card, close the memory card slot cover ( 31).
THIS PHOTO COULD NOT BE DELETED
- Protected photos cannot be deleted. Cancel the protection setting before deleting.
TOO MANY PHOTOS DISCONNECT USB CABLE
- Disconnect the USB cable and decrease the number of photos on the memory card to fewer than 1,800.
If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and restore the
connection after a short while.
TRANSFER ORDER ERROR
- You attempted to set more than 998 transfer orders. Reduce the number of photos marked with transfer
orders.
UNABLE TO RECOGNIZE THE DATA
- A memory card with data recorded in a different television system (PAL or SECAM) was inserted into the
camcorder.
UNABLE TO RECOVER DATA
- Could not recover a corrupted file.
WHILE THE CAMCORDER IS CONNECTED TO A PC DO NOT DISCONNECT THE USB CABLE OR POWER SOURCE
CANNOT TURN OFF POWER OR CHANGE MODES
- When the camcorder is in mode and is connected to the computer with a USB cable, the camcorder
cannot be operated. Disconnecting the USB cable or power source while this message appears may result in
permanent loss of the recordings in the camcorder. Use the computer's Safely Remove Hardware function to
end the connection and disconnect the USB cable before using the camcorder.
PHOTO
Start/Stop
COPY
Page view 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 122 123

Comments to this Manuals

No comments