Canon LX-MU500 User Manual download pdf (Page 56)

• The above-mentioned control may not be performed correctly or the monitoring data may not

be obtained correctly in the following conditions:

• During standby

• During input source switching

• During command processing

• During AUTO PC execution

• Before the splash screen disappears after the power is turned on.

• Use 1 computer to control/monitor 1 projector.

• For how to control/monitor using PJLink™, see the operation manual of the PJLink™

application you use.

• When you monitor the projector's operating state using this function by issuing inquiry

commands successively, issue an inquiry command after receiving the response to the

previous inquiry command from the projector.

Using the Network Function when the projector is in standby mode

When the Standby LAN in the SYSTEM SETUP: Advanced > LAN Settings menu is activated, the

projector is able to provide the network function when it is in standby mode.

Glossary

For more detail of the glossary below, refer to the technical book that is commercially available.

Term Description

DHCP

Abbreviation for Dynamic Host Configuration Protocol. This protocol

automatically assigns IP Address to networked devices.

IP Address Numerical address to identify networked computers.

Subnet Mask

A numeric value to define the number of bits used for a network

address of a divided network (or subnet) in an IP Address.

Default Gateway

A server (or router) to communicate across networks (subnets) that are

divided by Subnet Mask.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 84 85

No comments

Canon LX-MU500 User Manual Page 56