Canon imageCLASS MF5950dw User Manual

Read this guide before setting up the wireless LANThis guide describes the wireless LAN setup procedure and problems encountered during the configurat

1-8Setting the wireless LAN12. Press [ ] to select, and press [OK].13. Wait until the machine retrieves the IP address automatically (approx. 2 minu

2-1TroubleshootingTroubleshootingThis section describes the causes and solutions for the problems occurred during wireless LAN settings.To set and ope

2-2TroubleshootingWhen an Error Message Appears“Could not connect. More than one access point was detected.”CauseOther wireless LAN routers or access

2-3Troubleshooting”Could not connect. Check PSK settings.”CauseThe network key for the wireless LAN router or access point is not set to the machine c

2-4TroubleshootingIf Problems OccurCannot detect the SSID or network key of the wireless LAN router or access point.How to check: Proceed to “Checking

2-5Troubleshooting<Wireless LAN Settings> cannot be selected because it is grayed out in the Network Set-tings menu.CauseConnection method for t

2-6TroubleshootingChecking Network ConnectionsCheck the following items to make sure that the machine is ready to be connected to a network.1 Check th

2-7TroubleshootingDid you change the wireless LAN routers or access points security settings?If the following is the case, specify the settings manual

Appendix-1Appendix1. Press [ ] (Status Monitor/Cancel).2. Select with [ ] and [ ], and then press [OK].Status Monitor/Cancel TX Job RX Job Fax Forward

Appendix-2AppendixYou can check the SSID or the network key using “Canon MF/LBP Wireless Setup Assistant.”* “Canon MF/LBP Wireless Setup Assistant” i

Wireless LAN setting procedures can be referred from Canon’s home pageIf you are looking to install your new device via a Wireless Network connection

FT5-4318 (010) XXXXXXXXXX © CANON INC. 2011 PRINTED IN CHINACANON INC.30-2, Shimomaruko 3-chome, Ohta-ku, Tokyo 146-8501, JapanCANON MARKETING J

1-1Setting the wireless LANFor more information, see the instruction manual for the network device you are using, or contact the networking device man

1-2Setting the wireless LAN1. Press [ ] (Menu).2. Press [ ] or [ ] to select, and press [OK].The next screen is displayed for approximately 5 se

1-3Setting the wireless LAN Proceed to “Step4-A Setting the Machine Using the WPS (Push Button Mode),” on p.1-4. Proceed to “Step4-B Setting the Acces

1-4Setting the wireless LAN2. Press [ ] (Menu).1. Make sure the procedure “Step2 Switching the Connection Method to Wireless LAN” (P.1-2) is complet

1-5Setting the wireless LANThe next screen is displayed for approximately 2 seconds, and the Wi-Fi indicator will start blinking.10. Wait until the m

1-6Setting the wireless LAN SSID* May be indicated as name of access point or network. Network Key / Number of characters in the network key (numbe

1-7Setting the wireless LAN9. Press [ ] or [ ] to select the access point you wrote down in step 2, and then press [OK].Proceeding toscreen for en