Canon DR-6030C User Manual download pdf (Page 33)

Using the Scanner 27

Chapter 2

3. Placing Documents

There are two methods for paper separation, called the page separation mode

and bypass mode for feeding documents. Feeding documents continuously

from a stack of documents placed in the feed tray is called the page separation

mode. Feeding documents one sheet at a time by hand or feeding multiple

sheet documents, such as invoices that are attached at one end, is called the

bypass mode. The document feed method can be switched by moving the feed

selection lever.

IMPORTANT

• Before you place a document, check to make sure it does not contain paper

clips, staples, or other small metal objects. These objects may damage the

document, or cause a paper jam or scanner malfunction.

• Do not wear loose clothing or jewelry that may get caught in the scanner

while you are using it. This may result in personal injury. Be extra careful of

neckties and long hair. If anything becomes caught in the scanner,

immediately disconnect the power cord to stop scanning.

• Always smooth out any folds or curls in your documents before placing

them into the feeder. If the leading edge of a document is curled, it may

cause a paper jam.

• When continuously scanning documents on thin paper in page separation

mode, the pages may be wrinkled or folded and cause a paper jam. If this

happens, scan the document in the bypass mode.

How to Feed with the Page Separation Mode

Move the feed selection lever on the lower left side of the front of the scanner

up ( ).

Note

Lifting up the feed selection lever causes the document stoppers to rise.

Document Stoppers

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 144 145

No comments

Canon DR-6030C User Manual Page 33