Canon IP ReadyTM Series Video Alarm FDW75C12N Operations Instructions download pdf (Page 14)

- 13 -

INSTALLING QUICK RELEASE BRACKETS

ELMO PTC-401

Mounting plate for this unit is included in the housing

packet. Remove existing mounting plate installed in

the unit before proceeding.

2539 Mounting Plate:

1. Remove the mounting plate from the camera and

place it onto the quick release bracket using the (4)

metric 3M Phillips head screws provided with the kit.

Then place the ELMO mounting plate back onto the

Elmo PTC-401C.

Attach camera using these (4) holes

2. In the packet, there will be a number of 2 inch and 1

inch spacers. Take four of the 1 inch spacers and screw

them onto the spacers that are on the base bracket

(to make a 3 inch spacer). Place two 8/32 X 9 Philips

head screws on the three inch spacer in the dome. Be

sure to place the screws so they line up with the two

open screw slots on the quick release bracket. Place

the Elmo PTC-401C pan/tilt and quick release bracket

in the housing, sliding the two open screw slots over the

screws in the housing. Slide the bracket forward, and

then tighten the captive screw on the bracket.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

No comments

Canon IP ReadyTM Series Video Alarm FDW75C12N Operations Instructions Page 14