Canon VB101 User Manual download pdf (Page 54)

Appendix

106 107

When a new version of the firmware is released, the firmware can be upgraded remotely. To

upgrade remotely, use the "vbrfu.exe" program on the CD-ROM and the new software.

Obtain the new software.

Launch the "vbrfu.exe" program on the enclosed CD-ROM and used

the procedure below to perform the remote upgrade.

Upgrading the Firmware Remotely

Enter the IP address, user name and password.

The current version is displayed.

● Server address: Camera server IP address

● Administrator user name: Server administrator user name

● Administrator password: Server administrator password

Store the downloaded firmware in

flash ROM.

Specify the firmware file to be downloaded to the server.

(5) The completion window appears.

Visit the following Web site (URL:http:www.x-zone.canon.co.jp/WebView-E/index.htm)

for the latest information on new firmware.

Using the Enclosed Software

Use the "IniVB101.exe" and "inivb101.elf" files in the same directory on the enclosed CD-ROM to

restore the VB101 settings to the factory default values.

Connect the VB101 to your PC (→ P.31), insert the enclosed CD-ROM

into the CD-ROM drive and launch the "IniVB101.exe" program.

When the "IniVB101.exe" dialog box appears, perform steps

below to restore the factory default settings.

Switch the VB101 off and then

on again.

Select direct connection to COM1 as the connection method.

Enter "VB101" as the password (default setting).

● When you switch the VB101 on again,

the [Next] button is enabled.

● On some PCs you may have to select a port other than COM1.

Check the port number to which the serial cable is connected.

When the confirmation message

appears, click the [OK] button.

●The factory default setting are

restored

Note

● When you click the [Cancel] button after switching the VB101 back on, the power LED

remains lit orange. At this point, the VB101 software has not started up. If you do not

need to change the settings, switch the VB101 to off and then on again and check that

the power LED is green. To begin the setup procedure again, launch "IniVB101.exe"

and then switch the VB101 off and on again as directed by the on-screen instructions.

● If you forget the password, you will have to return the VB101 to a service center.

Please contact your Canon dealer.

● Refer to the previous pages for the factory default settings.

Restoring the Factory Default Settings

Using the Enclosed Software

Note

Do not turn the VB101 off until the completion window appears. Turning the VB101 off

before the Completion window appears may prevent the VB101 from starting up

properly. If this occurs, consult your Canon dealer or service outlet.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59

Comments to this Manuals

No comments

Canon VB101 User Manual Page 54

Comments to this Manuals

Related products and manuals for Security cameras Canon VB101