Canon EOS M3 User Manual Page 143

  • Download
  • Add to my manuals
  • Print
  • Page
    / 201
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 142
143
Advanced Guide
Basic Guide
1
Camera Basics
2
Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
Tv, Av, and M Mode
6
Playback Mode
7
Wi-Fi Functions
8
Set-Up Menu
9
Accessories
10
Appendix
Index
4
P Mode
5
Tv, Av, M, and C Modes
Before Use
For the most effective cleaning results, place the camera upright
on a desk or other surface before cleaning.
Repeated consecutive sensor cleanings will not produce notably
better results. [Clean now
] may not be available for selection
immediately after cleaning.
If there is dust or any other material on the image sensor that
the cleaning function cannot remove, contact a Canon Customer
Support Help Desk.
Cleaning Manually
If there is dust or dirt on the image sensor that the cleaner cannot remove,
try to clean it manually using a commercial blower or other device.
The image sensor is an extremely delicate component. If manual cleaning
is required, consulting with the Canon Service Center (listed in the
appendix) is strongly recommended.
1
Turn the camera off.
2
Detach the lens.
3
Clean the image sensor.
The image sensor is an extremely delicate component. Exercise
care when cleaning.
Do not use a blower equipped with a brush. Brushes can damage
the image sensor upon contact.
Do not insert the blower into the lens mount surface. This can
damage the shutter.
Do not clean with high-pressure air or gas. High-pressure airow
can damage the image sensor, and condensing or freezing gas
can damage the image sensor surface.
If the blower still fails to clean the image sensor, having the
sensor cleaned by a Canon Service Center is recommended.
2
Congure the settings.
Press the [ ][ ] buttons or turn the [ ]
dial to choose [Disable], and then press
the [ ] button.
Activating the Cleaner
1
Access the setting screen.
After turning the camera on in shooting
mode, choose [Sensor cleaning] on the
[ 3] tab and press the [ ] button.
Press the [
][ ] buttons or turn the [ ]
dial to choose [Clean now ], and then
press the [ ] button.
2
Clean the sensor.
Press the [ ][ ] buttons or turn the [ ]
dial to choose [OK], and then press the
[ ] button.
The screen will indicate that the sensor
is being cleaned. Although there will be a
shutter sound, a picture is not taken.
The sensor cleaning also works while no lens is attached. If no
lens is attached, do not insert your nger or blower tip beyond the
lens mount. This is to prevent damage to the shutter curtains.
Page view 142
1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 200 201

Comments to this Manuals

No comments