Canon SX80 Mark II User Manual download pdf (Page 146)

Maintenance

146

■ Replacing the Lamp

1 Turn off the projector, disconnect the

power plug from the AC outlet, and let

the projector stand for at least 1 hour.

2 As shown in the figure, insert a flat-

head screwdriver in the gap and

remove the lamp cover by raising it.

3 Loosen two screws with a phillips-

head screwdriver and then pull up the

handle.

* Pull up the handle as shown in the

figure.

4 Remove the lamp while holding the

center of the handle.

5 Fully insert a new lamp and secure it

with two screws.

* After the installation, be sure to

push down the handle.

6 As shown in the figure, replace the

lamp cover. Check whether the lamp

cover is installed securely.

7 Turn on the projector.

8 Bring up the menu and select [System

settings] -> [Other settings] -> [Lamp

counter]. (P109)

9 Select [Reset] -> [OK] to reset the

lamp counter.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 167 168

No comments

Canon SX80 Mark II User Manual Page 146