2 Rock the cartridge several times to distribute
toner inside.
1 Check the color marking on the cartridge
receptacle in the machine. Remove the toner
cartridge of the same color from the bag.
Protective
cover
3 Remove the protective cover.
Toner cartridge
memory
Developing roller
4 Hold the cartridge on a flat stable surface with
one hand, and pull out the seal completely
with the other hand.
Electrical
contacts
Sensor
5 Hold the cartridge as shown and insert it in
the machine as far as it will go.
6 Close the cartridge cover and wait for the
cartridge cradle to rotate and stop, and then
open the cover again.
IMPORTANT
●
Do not touch the developing roller, sensors, electrical contacts or cartridge memory on a toner cartridge.
Install the toner cartridges.
7 Repeat steps 1 to 6 above until all four toner cartridges are installed. Then close the cartridge
cover and lower the scanning platform.
NOTE
●
If an empty cartridge receptacle does not appear, close the cartridge cover and follow the steps below:
1 Press [Menu] on the control panel ➝ or to select <10.MAINTENANCE> on the LCD ➝ press [Set].
2 Press or to select <1.CHANGE CARTRIDGE> ➝ press [Set] ➝ <5.ALL COLORS> ➝ [Set].
3 Open the cartridge cover and install the remaining cartridges one by one. The cartridge receptacles should appear in this order: Y ➝ M ➝ C ➝ K.
Comments to this Manuals