Canon MP360 SERIES Service Manual Page 114

  • Download
  • Add to my manuals
  • Print
  • Page
    / 149
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 113
Chapter 5
5-13
5.3.2 New Error Codes and Recovery methods
0002-1662
Those error codes that have been added starting with the products and those error codes for which remedies unique
to the product are offered are shown together with causes and remedies, where applicable.
##341 Maintenance jet waste ink capacity full
Solution: Replace thewaste ink absorber as follows in the error occurs:
(1) Select 3. EEPROM CLEAR under [8] PRINTER TEST in TEST mode, and the select 0.
(2) Check to make sure that no image exist in memory; then, turn off the power, remove the appropriate parts, and
replace the waste ink absorber.
##342 Cleaning absorption waste ink capacity full
Solution: Replace thewaste ink absorber as follows in the error occurs:
(1) Select 3. EEPROM CLEAR under [8] PRINTER TEST in TEST mode, and the select 0.
(2) Check to make sure that no image exist in memory; then, turn off the power, remove the appropriate parts, and
replace the waste ink absorber.
##784 [TX]
In ECM transmission, ERR was received after transmission of EOR-
EOM
##785 [TX]
In ECM transmission, no significant signal can be received after
transmission of EOR-EOP, and the allowed number of procedure signal
re-transmissions was exceeded
##787 [TX]
In ECM transmission, DCN was received after transmission of EOR-
EOP
##788 [TX]
In ECM transmission, the allowed number of procedure signal re-
transmissions was exceeded or a T5 time-over (60 sec) condition
occurred after transmission of EOR-EOP
##789 [TX]
In ECM transmission, ERR was received after transmission of EOR-
EOP
##790 [RX] In ECM reception, ERR was transmitted after reception of EOR-Q
##791 [TX/RX]
During an ECM mode procedure, a signal other than a significant signal
was received
##792 [RX] In ECM reception, PPS-NULL between partial pages cannot be detected
##793 [RX]
In ECM reception, no effective frame was detected while signals were
received at high speed, and a time-over condition occurred
No. Tx or Rx Definition
Page view 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 148 149

Comments to this Manuals

No comments