Canon mx860 User Manual download pdf (Page 968)

100

101

Refer to the manual provided with the access point or contact its manufacturer to check the

access point settings, and then modify the machine settings.

How to Set a WEP/WPA/WPA2 Key

Check 4: When using wireless LAN, make sure that the machine is not place as

far away from the access point.

The access point is located indoors within the effective range for wireless communication.

Locate the machine within 50 m from the access point.

Check 5: When using wireless LAN, make sure that there is no obstruction.

Wireless communication between different rooms or floors is generally poor. Adjust the

location of the devices.

Check 6: When using wireless LAN, make sure that there is no source of radio

wave interference in your vicinity.

There may be a device such as a microwave oven using the same frequency bandwidth as

the wireless station. Place the wireless devices as far away from the interference source as

possible.

Check 7: Make sure that the network settings of the computer are correct.

For the procedures to connect a network device to the computer and set them up, refer to the

manual of your network device or contact its manufacturer.

Check 8: Make sure that the radio status is good and adjust the installation

positions while monitoring the radio status with Canon IJ Network Tool.

Monitoring Wireless LAN Status

Check 9: Make sure that the valid wireless channel is used.

The wireless channel to be used may be limited depending on wireless network devices

installed in the computer. Refer to the manual provided with your computer or your wireless

network device to specify the valid wireless channel.

Check 10: Make sure that the channel set to the access point is valid to

communicate with the computer, confirmed in Check 9.

If not, change the channel set to the access point.

Check 11: Make sure that the firewall of the security software is disabled.

If the firewall function of your security software is turned on, a message may appear warning

that Canon software is attempting to access the network. If the warning message appears,

set the security software to always allow access.

If using any programs that switch the network environment, check their settings. Some

programs will enable a firewall by default.

Check 12: When using a router, connect the printer and computer to the LAN

side (same network segment).

For placement:

When using wireless LAN, make sure that there is no barrier or obstacle between the access

point and the machine.

The Machine Cannot Be Detected in the Network

Check 1: Make sure that the machine is turned on.

Check 2: Make sure that the USB cable is connected properly.

Refer to the setup manual of the machine to connect the USB cable properly.

Check 3: Make sure that the machine setup is completed.

If not, refer to your setup manual of the machine to complete the machine setup.

Check 4: When using wired LAN, make sure that the LAN cable is connected

properly.

Page 968 of 997 pagesCannot Communicate With the Machine/Cannot Print from the Machine

1 ... 967 968 969 ... 997

Comments to this Manuals

No comments

Canon mx860 User Manual Page 968

Comments to this Manuals

Related products and manuals for Printers Canon mx860