Canon LX-MU500Z User Manual download pdf (Page 58)

58 Maintenance

Light source information

Getting to know the light source hour

When the projector is in operation, the duration (in hours) of light source usage is automatically

calculated by the built-in timer.

To obtain the light source hour information:

• Go to INFORMATION.

• Go to SYSTEM SETUP: Advanced > Light Source Settings.

Saving power

• Setting the Light Source Mode

Go to > Light Source Settings > Light Source Mode and press / to select a suitable light

source mode from among the provided modes.

Setting the projector in Economic/360 & Portrait mode saves power.

• Setting Auto Power Off

This function allows the projector to turn off automatically if no input signal is detected after a

set period of time to save power.

To set Auto Power Off, go to SYSTEM SETUP: Basic > Auto Power Off and press / .

Light source

mode

Description

Normal Provides full light source brightness

Economic Lowers brightness to save power and decreases the fan noise

360 & Portrait

Lowers brightness to save power. When the projector is installed in a tilt angle

over ±45 degrees and portrait projection, you need to select 360 & Portrait.

Refer to page 19.

• The apparent brightness of the projected image will vary depending on the ambient lighting

conditions, selected input signal contrast/brightness settings, and is directly proportional to

projection distance.

• The light source brightness will decline over time and may vary within the light source

manufacturers specifications. This is normal and expected behavior.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 72 73

No comments

Canon LX-MU500Z User Manual Page 58