Canon VB-C50i/VB-C50iR User Manual download pdf (Page 46)

3-6

Ethernet

1 “Address Setting Method”

Select an address setting method from “Auto Setting (DHCP)” or “Manual Setting”. If you select

“Auto Setting (DHCP)”, you can use the values automatically obtained from the DHCP server

for “IP Address”, “Subnet Mask” and “Default Gateway Address”. If you select “Manual Setting”,

directly enter values which suit your environment.

2 “IP Address”

Enter a network interface-specific IP address.

3 “Subnet Mask”

Enter the subnet mask specified for the network to be connected.

4 “Default Gateway Address”

Set this item when you want to connect to a different subnet within the intranet or a wide area

network such as the Internet.

5 “Maximum Transmission Unit”

Enter the maximum transmission unit size to be sent at one time. There is normally no need to

change this from 1500.

If you are using ADSL, the efficiency of data transmission may be improved if you slightly lower

tha value. When you are using Ethernet, maintain the value at 1500.

Note

● Contact the network administrator for the IP address, subnet mask and default

gateway address settings.

●

Take particular care with the IP address, subnet mask and default gateway address

settings. If errors are found in any of these items, you may be completely unable to

access the VB-C50i/VB-C50iR via Ethernet and it may only be possible to recover

the problem by using the Initial Setup Tool (→ P.2-7) to correct the error.

Connection Keeping

1 “Send packet regularly”

Check to enable this function.

2 “Target IP Address”

Specify where the packet should be sent.

3 “Interval (min.)”

Specify the interval at which a packet should be sent from 1 to 60 (min.).

Setting Up the Administrator Password and Ethernet etc. (System and Network)

003-VBC50i-E-US 06.7.6, 11:34 AM6

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 243 244

No comments

Canon VB-C50i/VB-C50iR User Manual Page 46