Canon VB-H630D Owner's Manual download pdf (Page 146)

146

Note

• When [Auto] or [Manual] is selected for smart shade control,

the video data size increases.

• When [Manual] is selected for smart shade control, setting a

high compensation strength may increase screen noise. If

noise is noticeable, lower the control level.

 Setting the Focus

[Auto]

:Automatically focuses on the

subject.

[Manual] : You can adjust the focus manually

by pushing the (far) and

(near) buttons.

Clicking [One-shot AF] will use

autofocus to focus on a subject and

then stop in manual focus.

[Fixed at Infinity] : You can set the focus so that it is

fixed near infinity.

 Setting the Exposure

(1) Exposure Mode

Select from [Auto], [Manual], [Auto (Flickerless)] or

[Auto (Shutter-priority AE)].

If [Auto] is selected for [Day/Night] under [Camera] in

the Setting page (p. 54), select [Auto], [Auto

(Flickerless)] or [Auto (Shutter-priority AE)].

[Auto]

The exposure is controlled automatically.

[Manual]

The exposure is set by adjusting the shutter speed,

aperture and gain values manually.

[Auto (Flickerless)]

In this mode, video flickering caused by fluorescent

lights, etc., can be reduced. The shutter speed is

automatically adjusted according to the brightness

of the environment in which the camera is used.

[Auto (Shutter-priority AE)]

In this mode, the desired shutter speed can be

specified.

(2) [Exposure Compensation]

When [Auto], [Auto (Flickerless)] or [Auto (Shutter-

priority AE)] is selected for [Exposure], the exposure

compensation value desired can be selected from

nine levels (-4 to +4) using the slider.

To darken the image, select a negative value. To

brighten the image, select a positive value.

(3) [Metering Mode]

When [Auto], [Auto (Flickerless)] or [Auto (Shutter-

priority AE)] is selected for [Exposure], the metering

mode can be selected from [Center-Weighted],

[Average] or [Spot].

Important

• If it is set in the Admin Viewer, the same focus mode will

occur in the viewers of other users also.

• Depending on the lighting used, focus may not be

maintained when switching between [Day Mode] and [Night

Mode]. Focus when switching Day/Night Mode can be set in

the [Day/Night Mode Focus Settings] panel in the Admin

Viewer (p. 148).

• Setting the shutter speed at [1/1 sec] in manual exposure

(p. 146) will disable the [Auto] and [One-shot AF] focus

modes in Control for Admin. Switch the focus to [Manual] and

adjust it to your subject.

• Refer to the following for focus ranges.

Notes on p. 55

Notes on p. 38

• Changes to focus mode in the Admin Viewer will not be

reflected in the settings on the setting page.

• Note that if you set the focus manually it will remain fixed.

(1)

(2)

(3)

(5)

(6)

(7)

(4)

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 185 186

Comments to this Manuals

No comments

Canon VB-H630D Owner's Manual Page 146

Comments to this Manuals

Related products and manuals for Document cameras Canon VB-H630D