Canon FAX-L280 User's Guide download pdf (Page 173)

Chapter 13 Troubleshooting 13-17

Troubleshooting

Toner may be low or unevenly distributed.

• Redistribute the toner inside the toner cartridge (1 p. 12-7). If the problem persists,

replace the toner cartridge (1 p. 12-7).

■ Cannot receive using Error Correction Mode (ECM).

The other party’s fax machine may not support ECM.

• If this is the case, the document is received without ECM.

ECM may be disabled.

• Make sure ECM on your FAX is enabled (1 ECM RX, p. 14-7).

• Contact the other party to check if ECM on their fax machine is enabled.

■ Errors occur frequently while receiving.

The telephone lines may be in poor condition, or you may have a bad

connection.

• Lower the reception speed (1 RX START SPEED, p. 14-10).

The other party’s fax machine may not be functioning properly.

• Contact the other party and have them check that their fax machine is functioning

properly.

Copying Problems

■ Cannot make copies.

The document may not be loaded correctly.

• Make sure the document is loaded correctly in the ADF (1 p. 4-3).

• Make sure the operation panel is closed.

The document may not meet the requirements for the FAX.

• Make sure you load documents that meet the requirements for the FAX (1 p. 4-2).

■ MEMORY FULL appears in the LCD when making multiple

copies.

The FAX’s memory is full.

• Print, send, or delete any documents stored in memory (1 p. 9-5) to free up space in

the FAX’s memory, then start again.

The document you are copying may have too many graphics.

• If multiple pages are being copied, separate the pages into smaller stacks. If not,

make the desired number of copies one at a time as needed.

For additional troubleshooting, see Printing Problems, p. 13-18.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 211 212

No comments

Canon FAX-L280 User's Guide Page 173