Canon MP360 SERIES Service Manual download pdf (Page 111)

Chapter 5

5-10

##287 [TX] DCN has been received after transmitting MPS

##288 [TX]

After transmitting EOP, a signal other than PIN, PIP, MCF, RTP, or RTN

was received

##289 [TX]

After transmitting EOM, a signal other than PIN,PIP,MCF, RTP, or RTN

was received

##290 [TX]

After transmitting MPS, a signal other than PIN,PIP,MCF, RTP, or RTN

was received

##332 [TX/RX] Printer control DRAM check error

##333 [TX/RX] Printer control ROM check error

##334 [TX/RX] Printer control EEPROM check error

##335 [TX/RX]

Data transmission error between the system control section and printer

control section

##336 [TX/RX] BJ head abnormal temperature error

##337 [RX] BJ head temperature sensor error

##338 [RX] Printing Position Correction Failed

##339 [RX] BJ Head Voltage Malfunction Error

##340 [RX] Home Position Error

Q ##341 [TX/RX] Maintenance Jet Waste Ink Tank Full

Q ##342 [TX/RX] Cleaning absorption waste ink capacity full

Q ##343 [TX/RX] Ink Detection Waste Ink Tank Full

##346 [TX/RX] Inside temperature error

W ##352 [RX] Printer control EEPROM head information error

##670 [TX]

In V.8 late start, the V.8 ability was detected in DIS from the other party

and, in response, CI was transmitted; however, the procedure failed to

advance, causing a T1 time-over condition

##671 [RX]

In V.8 call arrives, the procedure fails to advance to phase 2 after CM

detection, causing a T1 time-over condition

##672 [TX]

In V.34 transmission, the procedure fails to move from phase 2 to phase

3 and later, causing a T1 time-over condition

No. Tx or Rx Definition

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 148 149

No comments

Canon MP360 SERIES Service Manual Page 111