Canon MP360 SERIES Service Manual download pdf (Page 130)

Chapter 5

5-29

a) Sensor tests

Select the sensor test from the faculty test menu by pressing the numeric key 3 or keys. In this test, you can check

the status of each sensor of this fax in item 1 on the display. You can also check if sensors that use actuators and

microswitch are operating correctly by moving the actuator or microswitch.

NOTE:

The sensor tests cannot be used to test all of the sensors. The following sensors cannot be tested with the sensor tests:

Pickup sensor

If any of above sensors are faulty, an error message or service error code will appear to indicate the faulty sensor.

F-5-10

b) Operation panel tests

Press the numeric key 7 or and key form the faculty to select 6-7:operation panel tests from the faculty test menu.

In this test, check that the display, LED lamps, and keys on the control pane are operating correctly.

b-1) Display test

If you press Start key in the menu of the operation panel, 20 letters of "H" are displayed in two lines. If you press

Start key one more time, all the LCD dots are displayed. If you press Stat key again, "_"is displayed. Check if there

are no LCD dots that are not displayed by performing this operation.

b-2) LED lamp test

Press the Start key to select the LED lamp test after the display test is complete.

When the Start key is pressed, all the lamps on the control panel light. Check for any LED that does not light during

6-3: SENSOR

- 6 - 3 - 1 +

Select the "6-3-1", and press the set button.

Select the "6-3-3", and press the set button.

DS of DES of DOC A4

DS: Document sensor DES: Document edge sensor

on/of: document/no document

DOC: Document wide sensor A4

(DS, DES, and DOC these sensors are not in this machine)

CVR: Cover sensor on/of: open/close

PE: paper edge sensor on/of: document/no document

CVR on

PE of

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 148 149

No comments

Canon MP360 SERIES Service Manual Page 130