Canon imagePROGRAF iPF825 User Manual download pdf (Page 14)

Remove any loaded paper that will not be used.•

If the Wheeled Output Stacker is installed, remove it in advance. (→"Using the Wheeled Output Stacker," User

Manual)

•

If the Platen is dirty, clean inside the Top Cover . (→ , If Paper is Soiled) •

See the following procedure for instructions on attaching the Roll Holder to the roll.

•

Be careful not to pinch your ﬁ ngers between the Roll Holder shaft (a) and the guide grooves (b) when

loading rolls.

•

Rolls: (→ , Removing the Roll from the Printer) •

Sheets: (→

, Removing Sheets) •

After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper.

(→"Checking Instructions During Printer Operations," User Manual)

•

(→ , Attaching the Roll Holder to Rolls)

Conﬁ rm that a roll is selected as the paper source.

(→"Selecting the Paper Source," User Manual)

Holding the Roll Holder so that the side with the white

gear faces the side of the Roll Holder Slot with a white

gear, load the Roll Holder shaft (a) into the grooves (b)

on both ends of the Roll Holder Slot .

You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders. (iPF825 only)

Load a roll in the printer (iPF825: in the Roll 1 (Upper) position)

Open the Top Cover and lift the Ejection Guide .

Loading Rolls in the Printer

Load rolls in the printer as follows.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

No comments

Canon imagePROGRAF iPF825 User Manual Page 14