Canon Rebel Ti 300V User Manual download pdf (Page 43)

A’DEP :Automatic Depth-of-Field AE

This mode is for obtaining a wide depth of field automatically between a

near subject and far subject. It is effective for group photos and landscapes.

The camera uses the 7 AF points to detect the nearest and farthest sub

jects to be in focus.

* “A-DEP” stands for Auto-depth of field.

Turn the Command Dial to < A-DEP:

Focus the subject.

• Move the AF point over the subject

and press the shutter button halfway.

• All the subjects covered by the AF

points which flashed in red will be in

focus.

• If you press the depth-of-field preview

button while the exposure reading is

displayed in the viewfinder, you can

see the depth of field, (^page 41)

es 8,0

The < A-DEP > mode cannot be used if the lens' focus mode switch is set to

<MF> (or <M> on older lenses).

' If the aperture blinks, it indicates that the exposure level is correct but the

desired depth of field cannot be achieved. Either use a wide-angle lens or

move further away from the subjects.

’ In this shooting mode, you cannot freely change the shutter speed and

aperture. If the camera sets a slow shutter speed, hold the camera steady

or use a tripod.

If flash Is used, the result will be the same as using flash in the < P > mode.

Check the viewfinder display and

take the picture.

• In the example above, the focus will

be sharp between the front person on

the left and the rear person on the

right.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

No comments

Canon Rebel Ti 300V User Manual Page 43