Canon IMAGERUNNER 2022i User's Guide download pdf (Page 82)

Making Prints Using the Stack Bypass

2-29

Basic Operations

Making Prints Using the Stack Bypass

If you are making prints on labels, transparencies, or nonstandard paper size stock,

load the paper stock into the stack bypass.

IMPORTANT

•

Note the following points when using the stack bypass:

- Paper Quantity: one to approximately 80 sheets (22 lb bond (80 g/m

), stack

approximately 1/4" (5 mm) high)

- Paper Size: 3 3/4" x 5 7/8" to 11 3/4" x 17" (95 mm x 148 mm to 297 mm x 432 mm)

- Paper Weight: 17 to 32 lb bond (64 to 128 g/m

)

- Paper which has been rolled or curled must be straightened out prior to use, to allow

the paper to feed smoothly through the stack bypass (allowable curl amount: less than

3/8" (10 mm) for normal paper, less than 1/4" (5 mm) for heavyweight paper).

- Depending on the paper storage conditions, it may not be possible to feed some paper

into the stack bypass. In this case, set the amount of paper to less than 40 sheets

(80 g/m

•

Do not load different size/type paper at the same time.

•

Depending on the type of heavyweight paper you want to load, if you load multiple sheets

of heavyweight paper into the stack bypass, a paper jam may occur. In this case, load

only one sheet of heavyweight paper at a time.

•

When printing on special types of paper, such as heavyweight paper or transparencies,

be sure to correctly set the paper type, especially if you are using heavyweight paper. If

the type of paper is not set correctly, it could adversely affect the quality of the image.

Moreover, the fixing unit may become dirty and require a service repair, or the paper

could jam.

•

If you are printing on envelopes, do not allow more than 10 envelopes to accumulate in

the output tray. Always empty the output tray once 10 envelopes have accumulated.

•

If you select [Irreg. Size] for copying, you cannot use the Rotate Collate, Rotate Group,

Offset Collate, Offset Group, Staple, 1 2-Sided, 2 2-Sided, Book 2-Sided, 2-Page

Separation, or Image Combination mode. (See Chapter 1, “Introduction to Copying,” in

the Copying Guide.)

•

If you select [Envelope] for copying or printing, you cannot use the finishing modes,

1 2-Sided, 2 2-Sided, Book 2-Sided, 2-Page Separation, or Image Combination mode.

(See Chapter 1, “Introduction to Copying,” in the Copying Guide.)

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 411 412

Comments to this Manuals

No comments

Canon IMAGERUNNER 2022i User's Guide Page 82

Comments to this Manuals

Related products and manuals for Laser/LED printers Canon IMAGERUNNER 2022i