User Maintenance
167A-05L
The settings about adjustment of the machine including print position correction
for each paper source and print quality improvement are listed with short
descriptions. You can specify those settings when the machine is oine. Default
settings are marked with a dagger (
).
Asterisks (*)
● Settings marked with an asterisk (*) are not displayed depending on other settings and whether the paper
feeder or SD card (all of these being optional) is installed or not in the machine.
Adj. Print Position(P. 400)
Recovery Printing(P. 401)
Check Paper Size(P. 401)
Substitute Size(P. 401)
Short Edge Fd. Prty.(P. 402)
Sp. Transfer Mode(P. 402)
Special Print Mode A(P. 402)
Adj. Scndry Transfer(P. 403)
Wrinkle Correction(P. 403)
Afterimage Corr.(P. 404)
Sp. Transfer Mode 2(P. 404)
Special Deliv. Mode(P. 404)
Improve Toner Fixing(P. 405)
SD Card Maintenance(P. 405)
Special Print Mode(P. 405)
Special Print Adj. C(P. 407)
Barcode Adj. Mode(P. 407)
Update Firmware(P. 408)
Paper Feed Method(P. 408)
Show Job List(P. 409)
Import/Export Set.(P. 409)
Notify to Clean(P. 410)
Clean. Notif. Timing(P. 410)
Toner Check Timing(P. 410)
Spec Tnr Chk Timing(P. 411)
Adj. Print Position
You can adjust the print position for each paper source. Adjusting Print Position(P. 520)
Common
You can adjust the vertical/horizontal print position for printing on the rst page (front side) in 2-sided printing
mode. The print position on the second page (back side) follows the settings for the paper source available
when the printing is started.
Offset Y (2-Sided) / Offset X (2-Sided)
-5.0 to 0.0
to +5.0 (mm)
Multi-Purpose Tray
You can adjust the vertical/horizontal print position for printing on paper from the multi-purpose tray.
Offset Y (MP Tray) / Offset X (MP Tray)
-5.0 to 0.0
to +5.0 (mm)
Setting Menu List
400
Comments to this Manuals